U disk installed H3C-KYLIN server process

0.Using UltraISO to burn kylin3.3 system to U disk

1.ESC or DEL to enter the setup, click Boot, and the BootMode “UEFI” is changed to “Legacy”;

2.CTRL+A enter RAID setting

First click the initial initialization, click enter, select the space, and cancel the delete Select, click enter after selecting, then click create create click enter, select the space, deleteUncheck, the first version of the system disk is two 500g HDDs, and these two are directly used as raid1 as the system disk, and the remaining single is used as volume. Or follow the special requirements to do raid ESC exit, exit, and then yes, it will restart

3. Enter the graphical interface installation

Select the language, select the region and time, select the software (select the server), select the sda ​​of 500g, and then done, to set the root password, start the installation install

4.reboot , Enter the root password, enter the interface, enter the terminal, and then start formatting the disk

Example: mkfs.ext4 /dev/sdbmkfs.ext4 /dev/sdc...

5. Modify /etc/fstab, and then mount -a

Example UUID=4e022a1a-2764-4e07-9764-5ab99e5c2e6a / ext4 defaults 1 1UUID=194f7973-7d15-43 d8-bce1-1f86ad8b1b4b /boot ext4 defaults 1 2 UUID=c8c747c2-a4d5-4da5-94fc-31d11299bd3a swap swap defaults 0 0tmpfs /dev/shm tmpfs defaults 0 0devpts /dev/pts devpts gid=5< /span>,mode=620 0 0sysfs /sys sysfs defaults 0 0proc /proc proc defaults 0 0 /dev/sdb1 /opt/data1 ext4 defaults 0 0/dev/sdc1 /opt /data2 ext4 defaults 0 0/dev/sdd1 /opt/data3 ext4 defaults 0 0/dev/sde1 /opt/data4 ext4 defaults 0 < span class="hljs-number">0/dev/sdf1 /opt/data5 ext4 defaults 0 0 /dev/sdg1 /opt/data6 ext4 defaults 0 0 

6.df -Th Take a look, the basic system installation has been completed, and then configure the network, modify the system configuration, such as closing selinux, etc.