All,
I have a DL380 G4 server with the following drives:
> 2x 36.4GB – 15K
> 2x 36.4GB – 10K
> 2x 300GB – 10K
I am trying to figure out how to best configure these drives. This is
Hardware development generally refers to the hardware development of electronic products. The research and development of a kind of visible electronic products, such as mobile phones, mice, keyboards, and stereos are all hardware. Hardware development is a series of researches carried out in these areas. Hardware development is generally divided into: schematic design, circuit diagram design, PCB board design, test board production, functional testing, stability testing, single-chip design, small batch production, formal market or formal use and other steps.
All,
I have a DL380 G4 server with the following drives:
> 2x 36.4GB – 15K
> 2x 36.4GB – 10K
> 2x 300GB – 10K
I am trying to figure out how to best configure these drives. This is
1. SurfaceView is an inherited class of View, and a Surface dedicated to drawing is embedded in this view. You can control the format and size of this Surface. Surfaceview controls the drawing posi
I have 3x 4TB drives for ZRAID1 configuration (single parity drive)
After running
zpool create data zraid1 sdb sdc sdd My volume size is 10.9T, which is my expected stripe configuration
0.Using UltraISO to burn kylin3.3 system to U disk 1.ESC or DEL to enter the setup, click Boot, and the BootMode “UEFI” is changed to “Legacy”; 2.CTRL+A enter RAID setting First click the initial
This is a stupid question, but what is the “official” term for carrying this hard drive?
I need to know if I can purchase separately from the hard drive.
Yes, they can be removed from t
I’m in the new RAID controller market for Dell servers, I can choose between “PERC H700 512mb Cache” and “PERC H700 512mb NVDIMM Cache”. There is a $200 difference between the two cards , Can anyon
Off-line data recovery case of two hard drives in the disk array: One of the customer’s servers caused a red light on a hard drive for unknown reasons, but the server is still operating normally an
We have a ProLiant server with a Smart Array P440ar controller.
Due to about three weeks, the “do not remove” instructions on some SAS drives The light is on. Maybe after a power failure.
What is more suitable for ordinary servers:
>Multiple partitions, which are bundled into multiple RAID1 devices (/dev/md0,/dev/md1, …), there is no unmirrored partition.
>A big /dev/md0, and
I am using iron router for my meteor project, everything is going well, but I just encountered some strange behavior.
I have one The loop is set to a list of items that looks like this.