/* Formats
* Most of these names have the following convention:
* A = Alpha
* R = Red
* G = Green
* B = Blue
* X = Unused Bits
* P = Palette
* L = Luminance
* U = dU coordinate fo
Author: Simo
Router password recovery
Router password recovery
If you forget the router’s enable password, you will not be able to enter the privileged mode, so you will not be able to configure the router. If you want to reconfi
Which drive in RAID has a bad sector?
I use the LSI MegaRaid SAS controller to have 4 physical drives in a virtual drive. It seems that (at least) one of the drives has bad sectors, because:
>An error occurred while trying to bac
Virtualization – use SLC exchange on the VM host as RAM replacement is wise?
I have some old servers running virtual machines, but they are limited to 16GB RAM, which limits the number of VMs I can run and the options for RDS.
to So far, it has done a good job in test
How to move RAID 1 to RAID 1 0
I have two HP disks in RAID 1 (300 Gb), and want to have 2 additional disks in RAID 10, with a total of 600 Gb on C:. < p>
I want to know if it is possible to use the array configuration util
In addition to the dual UPS PS system, the advantage of RAID BBU
Today, I roughly measured the benefits of enabling write-back on the RAID controller on the server at work. It does not have a RAID battery backup unit (BBU), so write caching is currently disabled
Meteor and MRT – Iron: Router: No such package
I am learning Meteor 0.8.3 and trying to use iron-router to set up some basic routing
My smart.json contains:
{
packages: {
iron-router: {
git: https://github.com/EventedMind/iron-ro
Hardware – $ readMemh $ WRITEMH Related resources
Suddenly, I saw some verilog testbench code that uses $readmemh and $writememh. I understand it basically reads into memory and writes to memory. If you can point it out with these routines Some re
How to choose the best RAID settings on the PE2950
I have some Dell PowerEdge 2950s, which contain 4x 15k, 150GB Cheetah SAS drives. They will be VM hosts, CentOS running ESXi and Windows Server 2k8 clients. Some guests will host IIS servers , And
The ProLiant server does not accept the new hard drive in RAID 1 0?
I have a HP ProLiant DL380 G5, I have two logical drives configured with RAID. I have a logical drive RAID 10 and two 72 gb 10k sas 1 ports spare 376597- 001.
I have a hard drive that has fai